Fallout ripper kit PREORDER

The Ripper — Electronics Kit (Preorder)

Everything you need to bring your 3D-printed Ripper to life — no soldering required. The kit arrives fully assembled and tested, so you just connect it and go.

Pre-wired electronics (assembled & functional)

• Custom transition board for plug-and-play wiring
• Motor with wires
• Battery compartment with built-in on/off power switch
• Limit switch trigger with wire
• Digital voltmeter display with wires
• Nut for the on/off switch

Complete hardware set

• Screws: M3×16 (×1), M2.6×6 (×25), M2.3×10 (×8), M3×5 (×8), M4×20 (×2), M4×5 grub/headless (×2), M3×5 countersunk silver (×2)
• M4 nuts (×2), springs 5 mm (×2), bearings (×4)

Together with the printed parts, this is everything needed to assemble and run the prop.

Preorder — please read

The board is custom-made, and each kit is developed and produced to order. This can take 1–2 months before it ships. As a thank-you for your patience during the wait, preorders are offered at a discount.

Notes

• The photos show a prototype of the kit — the final version may differ (connectors and the board will come soldered).
• Electronics and hardware only — the printed prop and filament are not included. Pairs with the Ripper STL files or a printed body.